A good weld is equal parts strength and cleanliness — it holds under load and it looks like it belongs there. We weld mild steel and aluminum for everything from a single broken bracket to a full production run, with the certification and consistency to back the joint.
Materials we work with
- Mild steel — the workhorse for structural, industrial and general fabrication.
- Aluminum — lighter-weight welds for tanks, trailers, guards and specialty parts.
Our welding process
We run MIG (GMAW) welding for its speed, strength and clean, repeatable results across both steel and aluminum. It’s a process that scales well — the same control that produces a tidy one-off repair keeps a production run consistent from the first part to the last.
From small repairs to production
No job is too small and none too repetitive. Bring in a cracked frame, a broken implement or a piece that just needs to be made whole again, and we’ll fix it. Need fifty of the same part welded to the same spec? We’ll set it up so every one comes off the bench the same.
- One-off and emergency repairs.
- Small-batch custom fabrication.
- Repeatable production runs to a fixed spec.
Quality standards
Our welding is backed by CWB certification to CSA W47.1 — qualified welders and approved procedures — so the strength of the weld isn’t a matter of trust, it’s a matter of record. That standard applies whether the part is destined for a structural assembly or a one-time fix.
Where it shows up
- Trailer and equipment repairs.
- Industrial and agricultural components.
- Tanks, guards, brackets and custom parts.